Which two objects should you configure?

Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals. Some question sets might have more than one correct solution, while others might not have a correct solution.After you answer a question in this sections, you will NOT be able to return to it. As a result, these questions will not appear in the review screen.You plan to deploy an application as a cloud service. The application uses a virtual network to extend your on-premises network into Azure.You need to configure a site-to-site VPN for cross-premises network connections.Which two objects should you configure? Each correct answer presents part of the solution.A Site-to-Site VPN gateway connection is used to connect your on-premises network to an Azure virtual network over an IPsec/IKE (IKEv1 or IKEv2) VPN tunnel.Verify that you have an externally facing public IPv4 address for your VPN device. This IP address cannot be located behind a NAT.References: https://docs.microsoft.com/en-us/azure/vpn-gateway/vpn-gateway-howto-site-to-site-resource-manager-portal#VPNDevice

Question:

Which two objects should you configure?

Options:

Dynamic routing gateway

External-facing IPv6 address

VPN gateway

External-facing IPv4 address

Correct Answer

The Correct Answer for this Question is

Dynamic routing gateway
External-facing IPv4 address

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *