Which of the following sets of commands CANNOT be included in the plan to implement HSRP on a Layer 3 switch port?

Which of the following sets of commands CANNOT be included in the plan to implement HSRP on a Layer 3 switch port?Answer:The following set of commands cannot be included in the implementation plan to configure HSRP on a Layer 3 switch port:interface fastethernet switchport mode accessThis set of commands creates an access port on the switch. The access port can then be assigned to a VLAN. HSRP cannot be enabled on access ports. To enable HSRP on a switch port, the port has to be any of the following:EtherChannel port Refers to a Layer 3 switch port used for EtherChannelRouted port Refers to a Layer 3 port on a switch used for routingSwitch virtual interface (SVI) Refers to a Layer 2 switch port used for inter-VLAN routingThe interface port-channel and no switchport commands allow you to create a Layer 3 port-channel interface, which can be logically bound with other port-channel interfaces to form an EtherChannel. Port-channel interfaces can be configured as either Layer 2 or Layer 3 interfaces. The interface port-channel command is used to create a Layer 3 port-channel interface.The following set of commands creates a routed port:interface fastethernet no switchport ip addressRouted ports are physical Layer 3 interfaces that allow you to configure a switch as a router. The no switchport command allows the port to be used purely as a Layer 3 port. This command restarts the port thereby deleting any Layer 2 configuration settings on the switch.The following set of commands is used to create an SVI, which is a logical interface that allows you to enable inter-VLAN routing on Layer 3 switches:interface vlan ip addressSVIs are configured as VLAN interfaces and have at least one physical interface assigned to the VLANs.Objective:Infrastructure Services Sub-Objective:Configure and verify first-hop redundancy protocolsReferences:Catalyst 4500 Series Switch Cisco IOS Software Configuration Guide, 12.2(37)SG > Configuring Layer 3 Interface > Configuring VLANs as Layer 3 Interfaces

Question:

Which of the following sets of commands CANNOT be included in the plan to implement HSRP on a Layer 3 switch port?

Options:

interface port-channelno switchport

interface fastethernetno switchportip address

interface fastethernet switchport mode access

interface vlan ip address

Correct Answer

The Correct Answer for this Question is

interface fastethernet switchport mode access

Leave a Comment