Which command do you use on a switch to put an interface that is in Layer 3 mode into Layer 2 mode?

Which command do you use on a switch to put an interface that is in Layer 3 mode into Layer 2 mode?Answer:Use the switchport command to put an interface that is in Layer 3 mode into Layer 2 mode.switch(config-if)# switchportUse the no switchport command to remove Layer 2 configurations and return an interface to Layer 3 mode.switch(config-if)# no switchportThe enhanced multilayer switch image must be installed on the switch to use this command.The vlan vlan-id configuration command is used to configure VLAN characteristics for a specific VLAN. Use the no keyword without additional parameters to delete a VLAN.Objective:Layer 2 Technologies Sub-Objective:Configure and verify switch administrationReferences:Catalyst 3560 Switch Command Reference, Rel. 12.2(25)SEE > Catalyst 3560 Switch Cisco IOS Commands – shutdown through vtp > switchport Cisco > Cisco IOS Interface and Hardware Component Command Reference > switchport

Question:

Which command do you use on a switch to put an interface that is in Layer 3 mode into Layer 2 mode?

Options:

vlan

no vlan

switchport

no switchport

Correct Answer

The Correct Answer for this Question is

switchport

Leave a Comment