Which configuration adjustment could be made to enable the OSPF process to load balance traffic across multiple OSPF links?

Correct Answer for the Question – Which configuration adjustment could be made to enable the OSPF process to load balance traffic across multiple OSPF links? is given below When monitoring the OSPF operations in the network, you notice that the OSPF process is not load balancing traffic across multiple OSPF links. Which configuration adjustment could be … Read more

When configuring BGP on Cisco IOS XR Software, which address-family is enabled by default?

Correct Answer for the Question – When configuring BGP on Cisco IOS XR Software, which address-family is enabled by default? is given below When configuring BGP on Cisco IOS XR Software, which address-family is enabled by default?http://www.cisco.com/en/US/docs/ios_xr_sw/iosxr_r3.8/routing/command/reference/rr38bgp.pdfAn address family must be explicitly configured in the router configuration mode for the address family to be active in … Read more

How many IBGP sessions will be required to establish fully meshed IBGP peerings?

Correct Answer for the Question – How many IBGP sessions will be required to establish fully meshed IBGP peerings? is given below In an AS with 10 routers running IBGP, how many IBGP sessions will be required to establish fully meshed IBGP peerings? 10 20 45 50 99 100 Correct Answer The Correct Answer for this … Read more

What are three common problems that can cause a BGP neighbor state to toggle between the idle state and the active state?

Correct Answer for the Question – What are three common problems that can cause a BGP neighbor state to toggle between the idle state and the active state? is given below What are three common problems that can cause a BGP neighbor state to toggle between the idle state and the active state? (Choose three.) BGP … Read more

Which four statements are correct regarding IS-IS operations?

Correct Answer for the Question – Which four statements are correct regarding IS-IS operations? is given below Which four statements are correct regarding IS-IS operations? (Choose four.)http://www.cisco.com/en/US/docs/ios_xr_sw/iosxr_r3.0/routing/configuration/guide/rc3isis.html#wp1148617Single-Topology IPv6 SupportSingle-topology IPv6 support on Cisco IOS XR software allows IS-IS for IPv6 to be configured on interfaces along with an IPv4 network protocol. All interfaces must be configured … Read more

Which option describes the configuration for a Cisco IOS XR OSPF router to give it the highest chances of becoming DR?

Correct Answer for the Question – Which option describes the configuration for a Cisco IOS XR OSPF router to give it the highest chances of becoming DR? is given below Which option describes the configuration for a Cisco IOS XR OSPF router to give it the highest chances of becoming DR? ip ospf priority 0 under … Read more

Which option describes how an engineer must configure route summarization on a Cisco IOS XE OSPF-enabled network of routers?

Correct Answer for the Question – Which option describes how an engineer must configure route summarization on a Cisco IOS XE OSPF-enabled network of routers? is given below Which option describes how an engineer must configure route summarization on a Cisco IOS XE OSPF-enabled network of routers? area range command under the router OSPF process of … Read more

Which three BGP configuration groupings are supported on Cisco IOS XR Software?

Correct Answer for the Question – Which three BGP configuration groupings are supported on Cisco IOS XR Software? is given below Which three BGP configuration groupings are supported on Cisco IOS XR Software? (Choose three.)•Commands relating to a peer group found in Cisco IOS Release 12.2 have been removed from Cisco IOS XR software. Instead, the … Read more

Which two OSPF network scenarios require OSPF virtual link configuration?

Correct Answer for the Question – Which two OSPF network scenarios require OSPF virtual link configuration? is given below Which two OSPF network scenarios require OSPF virtual link configuration? (Choose two.) to connect an OSPF non-backbone area to area 0 through another non-backbone area to connect an NSSA area to an external routing domain to connect … Read more